LEMFÖRDER 37313 01 Inner Tie Rod For Ford FIESTA VI

LEMFÖRDER 37313 01 Inner Tie Rod for Ford FIESTA VI

The LEMFÖRDER 37313 01 Inner Tie Rod is a precision‑engineered component designed specifically for the front axle of the Ford Fiesta VI. It serves as an essential link between the steering rack and the wheel hub, translating driver input into accurate wheel movement.

Key Functional Characteristics

• High‑strength construction: Made from hardened steel to withstand constant torque and lateral forces during cornering.
• Exact dimensional fit: Matches the original Ford specifications, ensuring seamless integration with existing steering geometry.
• Corrosion resistance: Coated to protect against rust in varied climates, extending service life.
• Low‑friction joint: Designed for smooth operation, reducing wear on adjacent components such as the tie rod end and wheel bearings.

Installation Overview

Replacing an inner tie rod is a straightforward task when following proper procedure. Below is a concise guide to help technicians or knowledgeable owners perform the replacement safely:

1. Secure the vehicle: Raise the front of the car on jack stands and remove the wheel.
2. Disconnect the steering rack: Loosen the tie rod nut that attaches the inner rod to the steering rack. Carefully detach the rod, noting its orientation for correct reassembly.
3. Remove the old tie rod: Unbolt the outer end of the rod from the wheel hub or brake assembly. Use a breaker bar if necessary to relieve tension.
4. Install the new inner tie rod: Position the LEMFÖRDER component, aligning it with the steering rack and wheel hub. Tighten all fasteners to manufacturer torque specifications.
5. Recheck alignment: After installation, perform a basic alignment check by turning the steering wheel through its full range while observing wheel movement for any binding or uneven motion.

Compatibility and Vehicle Coverage

The LEMFÖRDER 37313 01 Inner Tie Rod is engineered to fit a broad spectrum of Ford models that share the same front axle architecture. Primary compatibility includes:

• Ford Fiesta VI (including van variants)
• Ford B‑MAX and Transit derivatives with similar steering setups
• Other Ford vehicles utilizing the CB1 or CCN chassis codes, such as certain FIESTA V models

Because the part is a direct replacement for the OEM component, it maintains the original steering geometry and handling characteristics of the vehicle.

Material & Manufacturing Excellence

The inner tie rod’s construction follows stringent quality controls:

• Steel alloy selection: High‑grade alloy chosen for optimal strength-to-weight ratio.
• Heat treatment: Precise tempering process ensures durability under repeated stress cycles.
• Surface finishing: Protective coating applied to mitigate corrosion and reduce friction at the joint interface.

Performance Benefits

• Improved steering feel: The robust design delivers crisp, responsive feedback to the driver.
• Enhanced safety: Reliable load transfer between steering rack and wheel hub reduces risk of component failure during high‑speed maneuvers.
• Longevity: With proper installation and maintenance, the part can outlast many aftermarket alternatives.

Maintenance Tips

While the inner tie rod is designed for long service life, periodic checks are advisable:

• Inspect for visible wear or damage after significant off‑road use.
• Verify torque on all fasteners during routine maintenance intervals.
• Check steering wheel alignment and adjust if necessary to prevent uneven tire wear.

Conclusion

The LEMFÖRDER 37313 01 Inner Tie Rod exemplifies engineering precision tailored for the Ford Fiesta VI’s front axle. Its high‑strength construction, exact fitment, and proven durability make it a reliable choice for anyone seeking to maintain or restore optimal steering performance.