ABS 200431 Wheel Bearing Kit

ABS 200431 Wheel Bearing Kit

The ABS 200431 Wheel Bearing Kit is a high‑performance component designed to provide reliable rotation and load support for the front or rear wheels of selected Ford and Mazda models. Crafted with precision engineering, this kit delivers durability, smooth operation, and long‑term stability under varying driving conditions.

Technical Specifications

• Model Reference: 200431
• Manufacturer: ABS All Brake Systems BV
• Material Composition: Premium alloy steel with heat‑treated bearing races for enhanced wear resistance.
• Bearing Type: Deep groove ball bearings, suitable for high radial and axial loads.
• Dimensions: Inner diameter: 55 mm; Outer diameter: 115 mm; Width: 30 mm (exact dimensions may vary slightly per vehicle).
• Seal Type: Dual rubber seals to prevent dust ingress and retain lubrication.
• Lubrication: Pre‑lubricated with high‑quality grease, ensuring optimal performance from the first use.

Vehicle Compatibility

The kit is engineered for a range of compact and mid‑size vehicles. Key models include:

• Ford Fiesta (2003–2010)
• Ford Focus (2004–2011)
• Ford Fusion (2005–2012)
• Ford StreetKa (2006–2011)
• Ford Puma (2003–2010)
• Mazda 2 (2004–2011)

For each model, the kit is available in both front and rear wheel configurations. The part numbers for specific applications are:

• Front Wheel: 1085565, 1201568, 1212547
• Rear Wheel: 98AB1A034AC, 1126513, 1212548, 2S411A154AA, 2S411A154CA

Installation Guide

Installing the ABS 200431 Wheel Bearing Kit requires careful attention to detail. Follow these steps for a flawless fit:

1. Preparation: Secure the vehicle on a flat surface and lift it using a jack. Remove the wheel and brake assembly.
2. Remove Old Bearings: Use a bearing puller to extract the existing bearings from the hub. Clean all debris with a solvent.
3. Inspect Hub: Check for wear or damage on the hub races. Replace if necessary.
4. Install New Bearings: Place the new bearings into the hub, ensuring correct orientation. Apply a light coat of grease to the seals.
5. Reassemble Brakes: Reinstall brake calipers and pads, tightening all fasteners in the specified sequence.
6. Wheel Installation: Mount the wheel back onto the hub, torque the lug nuts to manufacturer specifications.
7. Final Checks: Verify that the wheel spins freely without wobble. Perform a test drive at low speed to confirm smooth operation.

Maintenance Tips

Even though the kit comes pre‑lubricated, regular maintenance extends its lifespan:

• Periodic Inspection: Every 10,000 miles, check for bearing noise or vibration.
• Seal Replacement: Replace rubber seals if they show signs of cracking or wear.
• Lubrication Refresh: Apply a thin layer of high‑temperature grease to the bearings every 20,000 miles.
• Wheel Alignment: Ensure proper alignment after any suspension work to prevent uneven bearing wear.

Performance Benefits

The ABS 200431 Wheel Bearing Kit offers several advantages that enhance driving safety and comfort:

• Reduced Vibration: Smooth bearings minimize wheel shake, improving ride quality.
• Enhanced Load Capacity: Strong alloy construction supports heavier loads without compromising performance.
• Longer Service Life: Heat‑treated races and sealed design resist corrosion and wear.
• Quiet Operation: Low noise levels contribute to a more pleasant driving experience.

Conclusion

The ABS 200431 Wheel Bearing Kit is an essential upgrade for owners of compatible Ford and Mazda vehicles seeking reliable wheel support, reduced vibration, and extended component life. Its robust construction, precise fitment, and straightforward installation make it a top choice for both professional mechanics and knowledgeable DIY enthusiasts.