METZGER Parking Sensors MERCEDESBENZ 0901054 05120341AA5120341AA0015427418 00354287180045428718A0015427418A0035428718A0045428718

METZGER Parking Sensors

The METZGER Parking Sensor 0901054 is a high‑performance, OEM‑grade sensor designed for a wide range of Mercedes‑Benz and Maybach models. It delivers precise distance measurement, reliable signal transmission, and seamless integration with the vehicle’s existing parking assistance system.

Key Features

• Ultra‑accurate detection: Uses advanced radar technology to measure distances from 0.2 m up to 4 m with an accuracy of ±1 cm, ensuring safe maneuvering in tight spaces.
• Wide compatibility: Fits front and rear sensor locations on models such as W203, S203, CL203, C209, A209, W211, W163, W251, V251, C219, R230, and many others. The sensor is also suitable for Maybach 57, SL, CLK, CLS, SLK, and T‑Model variants.
• Robust construction: Encased in a weather‑sealed housing that resists moisture, dust, and temperature extremes from –40 °C to +85 °C. The sensor’s mounting flange is engineered for secure attachment on both steel and aluminum chassis.
• Seamless integration: Designed to work with the vehicle’s original PDC (Parking Distance Control) system, providing audible beeps or visual alerts that match the factory interface.
• Low power consumption: Operates on the vehicle’s existing electrical architecture without requiring additional wiring or adapters.

The sensor is installed in a standard 18 mm mounting hole, typically located behind the front grille or rear bumper. The installation process involves:

1. Removing the existing aftermarket or damaged sensor (if applicable).
2. Aligning the new sensor’s mounting flange with the vehicle’s mounting points.
3. Screwing the sensor into place using the supplied fasteners, ensuring a tight fit to prevent vibration.
4. Connecting the sensor’s wiring harness to the vehicle’s existing PDC connector. The harness is pre‑wired for direct plug‑and‑play compatibility.
5. Testing the sensor by activating the parking assist system and verifying that distance alerts function correctly.

The following table lists the primary Mercedes‑Benz and Maybach models that officially support the METZGER Parking Sensor 0901054. The sensor is available for both front and rear positions, depending on the vehicle’s configuration.

• Enhanced safety: Accurate distance alerts reduce the risk of collisions during parking and low‑speed maneuvers.
• Convenience: The sensor’s integration with the vehicle’s existing system means drivers receive familiar audio/visual cues without additional learning curves.
• Reliability: OEM‑grade components ensure long‑term durability and consistent performance across varying environmental conditions.
• Easy maintenance: The sensor can be inspected or replaced with minimal disassembly, preserving the vehicle’s original aesthetic.

1. Ensure the mounting surface is clean and free of debris before installation to prevent misalignment.
2. Use a torque wrench to tighten the sensor screws to the manufacturer’s specified torque (typically 5–7 Nm) to avoid over‑ or under‑tightening.
3. Verify that the wiring harness is routed away from moving parts and protected by heat shields if necessary.
4. After installation, perform a diagnostic check using the vehicle’s onboard diagnostics port to confirm sensor status.

The METZGER Parking Sensor 0901054 represents a blend of precision engineering and practical design. Its compatibility with a broad spectrum of Mercedes‑Benz and Maybach models, coupled with its robust construction and seamless integration, makes it an ideal choice for drivers seeking reliable parking assistance without compromising on quality or performance.