MEYLE Track Control Arm 7160500008

MEYLE Track Control Arm 7160500008

The MEYLE Track Control Arm 7160500008 is a high‑performance suspension component engineered to deliver precise handling and reliable durability for the Ford Focus Mk1 (3/5‑door models). Designed with meticulous attention to detail, this control arm replaces worn or damaged parts in the front left side of the vehicle, restoring optimal ride quality and steering response.

Key Features

• Precision Engineering: Manufactured using advanced alloy steel, the arm offers a robust yet lightweight construction that resists fatigue under repeated stress cycles.
• Exact Fitment: The component is stamped to match the original Ford specifications for the Focus Mk1, ensuring seamless integration with existing suspension geometry.
• Improved Handling: By maintaining correct wheel alignment angles, the control arm enhances cornering stability and reduces tire wear.
• Easy Installation: Designed for straightforward replacement, it requires standard tools and a moderate amount of mechanical skill.
• Long‑Term Reliability: Corrosion-resistant coating protects against harsh road conditions, extending the life expectancy beyond that of many aftermarket alternatives.

Technical Specifications

Installation Guide

The following steps outline a typical installation procedure for the MEYLE Track Control Arm 7160500008. Always consult your vehicle’s service manual and wear appropriate safety gear.

1. Secure the Vehicle: Raise the front left side using a hydraulic jack, support with jack stands, and remove the wheel.
2. Disconnect Suspension Components: Loosen the upper ball joint nut, detach the sway bar link, and release any tie‑rod connections if necessary.
3. Remove the Old Control Arm: Unbolt the lower mounting point, then carefully lift the arm out of its cradle.
4. Position the New Arm: Align the MEYLE Track Control Arm with the existing brackets and ensure that all attachment points match.
5. Secure Mounting Points: Tighten the lower mounting bolt to the specified torque (typically 80–100 Nm). Reattach the upper ball joint and sway bar link, following manufacturer torque values.
6. Reinstall Wheel and Lower Components: Place the wheel back on, lower the vehicle, and re‑torque all lug nuts.
7. Alignment Check: Perform a post‑installation alignment to confirm that camber, caster, and toe angles are within factory specifications.

Benefits of Choosing MEYLE

• Authentic Performance: The arm’s geometry matches the original design, preserving the vehicle’s intended handling characteristics.
• Durability Under Stress: Alloy construction withstands high loads during aggressive driving or off‑road use.
• Reduced Maintenance: A reliable component reduces the likelihood of premature wear on adjacent suspension parts.
• Enhanced Safety: Proper alignment and robust mounting contribute to safer steering response and braking performance.

Maintenance Tips

Although the MEYLE Track Control Arm 7160500008 is built for longevity, routine inspections can further extend its life:

• Check bolt torque every 10,000 km or after any significant impact.
• Inspect for signs of corrosion or wear on the mounting surfaces.
• Ensure that bushings and ball joints remain lubricated and free from damage.

Conclusion

The MEYLE Track Control Arm 7160500008 represents a blend of precision engineering, durable materials, and design fidelity to the Ford Focus Mk1. Whether restoring a classic vehicle or upgrading an existing setup, this component delivers reliable performance, improved handling, and peace of mind for drivers who demand quality in every corner of their suspension system.